A customer can register Command Passthrough to receive commands sent by a remote device(Dimmer Switch, Alarm Device) and pass commands through to Host Micro, RapidHA automatically processing the command payload.

This is typically done so that the command payload an and corresponding expected action can be handled by the Host Micro-controller.

Step-by-step guide

Summary 

1. Setup Register Command Passthrough for desired cluster during startup config.
2. Setup Network.
3. Join Device.
4. Bind Device to Coordinator.
5. (If using RapidHA Desktop) Close/open com port

Register Command Passthrough

For this, a customer without a working host micro can use the RapidHA Serial Log feature to send the command-passthru frames during startup configuration.

1. Start RapidHA Desktop and open the Serial Log
2. Open comport and set the desired configuration
3. Take note of frames passed from Host to Module
   1. Example :

      [09:57:31]: F1 03 00 B9 02 00 00 BE 00 [RHADeviceTypeWrite]
      [09:57:31]: F1 03 30 BA 00 ED 00 [RHAClearEndpointConfig]

      ...... 

4. Resend frames but add the /wiki/spaces/SPRHA15/pages/37093429 before sending StartupSyncComplete frame. This can be done using RapidHA Desktop by parsing the Frames and manually enter using the Serial Log.

Setup Network

This is done as normal

Join Device

This is done as normal.

Bind Device To Controller

Please follow Step 1 of this guide to bind the device cluster to the coordinator