...
The serial UART interface uses the following parameters:
Table 1: RapidHA Serial Parameters
| Parameter | Value |
|---|---|
| Baud Rate | 115200 |
| Parity | None |
| Stop Bits | 1 |
| Data Bits | 8 |
Frame Structure
Every RapidHA frame has the structure illustrated below:
...
| Byte | Field Name | Description |
|---|---|---|
| 0 | Start of Frame | Fixed value of 0xF1; will be referred to as START_OF_FRAME throughout this document. |
| 1 | Primary Header | Defines the primary frame type. These are listed in /wiki/spaces/SPRHA17/pages/37093546. |
| 2 | Secondary Header | Identifies the command subset of the given primary frame type. These are listed in /wiki/spaces/SPRHA17/pages/37093546. |
| 3 | Frame Sequence Number | 0 – 127: Host initiated transactions 128 – 255: Module initiated transactions The Frame Sequence Number enumerates a serial message exchanged between the Host and the Module, and vice versa. Use of a Frame Sequence Number for each such message is recommended. For best practice, we also recommend the Frame Sequence Number be incremented by 1 for each newly initiated message. The response to a message must use the same Frame Sequence Number as the message that is being responded to. Any transaction, whether initiated by the Host or the Module, may be acknowledged (i.e., ACK'ed) by the recipient with a response using the same Frame Sequence Number. The Frame Sequence Number is used for tracking purposes but is not a mandatory feature. If its use is not desired, it should be assigned a value of 0x00. |
| 4 | Payload Length | Defines the length of the payload of a received or transmitted frame as 0-n bytes; at the time of this writing, the maximum acceptable values for n are:
Received by Module – 0x7A or 122 bytes |
...
Payload
Unlike the header, the payload is of variable size, ranging from 0 to n bytes; the size is based on the Payload Length field in the header. All fields contained in the payload are ordered with the least significant byte first.
...