( PH:0x02, SH:0x20 ) - Trust Center Install Code AddOverviewThe Trust Center Install Code Add command is sent by the Host to the Module to commission a new device to the network with that install code. This is used in the scenario when Module is configured as a coordinator (trust center) and trying to commission other devices onto the network. Module will use a link key derived from the install code to authenticate the joining device. Host must add the install codes before opening the permit join window for devices to join. The install codes are cleared when Module leaves the network, or loses power, or receives the command Clear Trust Center Install Codes. The maximum number of device install codes that can be added is indicated by Trust Center Install Code Max Count Response(Default size of 3). NOTE: The Maximum number of devices that can be added by install code at once is 3. Once devices have been commissioned onto the network, the Install Codes should be cleared by sending the 'Clear Trust Center Install Codes' command or waiting 5 minutes for the Install Code table to clear. Once new Install Codes are added using this command, the user should initiate network steering to commission the new devices. Users implementing their own Host application should consider how users will commissioning devices using Install Codes and provide the required interfaces. Payload |