A) Form Network

After completing Step 1: Hardware Configuration, return to the RapidConnect Desktop instance for the Combined Interface Coordinator and go to the Network Settings page.

This guide will assume that default values are used for the APS Link Key parameters and the 'Auto' options are checked for PAN ID and Extended PAN ID.

The 'Auto' options will generate random values for both PANID and Extended PAN ID.

The Network Settings page shows the following components:

Network Configuration Parameters
Network Actions
Permit Join Window
APS Link Key Parameters
Serial Log Viewer
Network Status

To form a zigbee network, click the ‘Form Network’ button. RapidConnect Desktop will send the necessary commands to the RapidConnect device to prompt it to form a zigbee network with the selected parameters. If multiple channels are selected, the channel with the least RF traffic will be chosen. Alternatively, the user can select a specific channel on which to form a network.

Once network forming is complete, RapidConnect Desktop will enable the 'Leave Network' button (1) and show the new network status and network information (3). The Serial Log Viewer will also be populated with serial messages sent between the Host (RapidConnect Desktop) and the device (2).

B) Join Network

It is now time to enable devices to join the newly formed zigbee network and then prompt the Dimmable Light to join.

Go to the RapidConnect desktop instance that interfaces to the Combined Interface Coordinator. From here, open the Network Settings window from the top menu bar. Go to the Permit Join area and set a duration (e.g. 60 seconds). Click the ‘Open’ button.

The ‘Open Forever’ button will open the permit join window for 248 seconds. Once that duration elapses, the permit join duration will automatically reset to 248 seconds, repeating indefinitely. MMB does not recommend using this setting in an environment with many zigbee devices, as it may lead to unintended devices joining the network. If using this setting, remember to use the ‘Close’ button to set the permit join duration to 0 after all intended devices have joined.

Once the permit join window is open, switch to the RapidConnect Desktop instance for the Dimmable Light device. Open the ‘Network Settings’ window from the menu.

Once the Network Settings window is open, click the ‘Join Network’ button to initialize the joining process.

The Serial Log Viewer will show the frames being sent to and from the RapidConnect device over USB. Once the Dimmable Light device joins a network, the Network Status (shown at the bottom of the screen) will be updated and the network configuration will reflect the information of the joined network.

Next Steps

You can now move on to Step 3: Lighting Device Control Example.

Browser not supported