...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
Identify Start Command
RapidHA Primary Header | 0x11 (General Cluster Frames) |
---|---|
RapidHA Secondary Header | 0x10 |
...
F1 11 10 DE 01 16 16 01 [RHAIdentifyStart]
Identify Stop Command
RapidHA Primary Header | 0x11 (General Cluster Frames) |
---|---|
RapidHA Secondary Header | 0x11 |
...
F1 11 11 E3 01 16 1C 01 [RHAIdentifyStop]
On/Off Status Update
RapidHA Primary Header | 0x12 (HA Cluster Frames) |
---|---|
RapidHA Secondary Header | 0x00 |
...
- (Indicating OFF) F1 12 00 DF 03 16 00 00 0A 01 [RHAOnOffStateUpdate]
Move to Level with On/Off Status
RapidHA Primary Header | 0x12 (HA Cluster Frames) |
---|---|
RapidHA Secondary Header | 0x25 (note that this is different from the secondary header for the Move to Level command, which is 0x20) |
...
- (Indicating Level 100, Transition Time 0, On/Off Status ON) F1 12 25 BB 05 16 64 00 00 01 72 01 [RHAMoveToLevel]
Module Triggered Restore to Factory Defaults Command
RapidHA Primary Header | 0x11 (HA Cluster) |
---|---|
RapidHA Secondary Header | 0x00 |
Payload
The command has no payload.
Expected Host Action
The Received Reset to Factory Default command is sent by the Module to the Host on reception of a Basic cluster Reset to Factory Default command from the network.
...
If applicable, after Host restored to factory default, the Host should also sends Attribute Write command serial command to update ZigBee cluster attribute value.
Host Triggered Restore to Factory Defaults Command
RapidHA Primary Header | 0x55 (Utility Frames) |
---|---|
RapidHA Secondary Header | 0x10 |
...
This command is typically triggered by Host when there is a manual Human action on the Host to Restore the Entire Device to Factory Default.
Effect on Receipt
The Module restores all non-volatile elements to their factory default settings, leaves the network if it is joined to one or dissolves the network if it has formed one, and then reboots.
Network Status Response Command
RapidHA Primary Header | 0x01 (Network Commissioning Frame) |
---|---|
RapidHA Secondary Header | 0x09 |
...
The Network Status Response is sent by the Module to the Host, either as a response to the Network Status Request command, or automatically upon a change to the application Network State or Permit Join Duration (i.e., on transition from non-zero to zero or vice versa).
Payload for Network Status Response Command
Byte Index | Field Name | Notes |
---|---|---|
0 | Network State | 0x00 = Network Down |
1 | ZigBee Device Type | 0x00 = Coordinator |
2 | Channel | 0xFF = Unknown |
3,4 | Node ID | 0xFFFF = Unknown |
5,6 | PAN ID | 0xFFFF = Unknown |
7..14 | Extended PAN ID | All 0’s = Unknown |
15 | Permit Join Time | The remaining Permit Join Duration at the time of issuance. |
...