This page shows the pinout that has been pre-configured in the RapidConnect Lighting & Sensor firmware. For more details regarding peripheral compatibility or use
Interface Summary
Digital In: PIR Occupancy Sensor, Ultrasonic Occupancy Sensor, Factory Reset Button
Analog In: Illuminance Measurement Sensor
Digital Out: Network Status LED (PTI_DATA), Relay
Analog Out: PWM
Serial: UART TX, UART RX
Others: nReset, VCC, GND, JTDO, JTCK, JTD, JTMS, JRST, PTI_EN
Pinout Using Z357PA40-SMT Module
Notes:
- All pins have maximum sourcing and sinking current of 4mA.
- EM357 runs off a 3.3V
- (*) indicates ADC capable pin
- (#) indicates PWM capable pin
| Module Pad | Function | Relation to zigbee Features | EM357 GPIO | Hardware Integration Comments |
|---|---|---|---|---|
| 1 | PIR Digital In | When this input is triggered, the Occupancy Sensor Endpoint will inform the network that Occupancy is "true" | PC6 (13) |
|
| 2 | Relay Out | When On/Off commands are sent to the Dimmable Light Endpoint, this | PC7 (14) | OUTPUT - Digital (Active High) |
| 3 | Reserved | PA7 (18)# | Reserved for Future PWM | |
| 4 | VCC (3.3 VDC) | |||
| 5 | nCTS / SPI Slave CLK | PB3 (19)# | Reserved for Future PWM | |
| 6 | nRTS / SPI Select (Host Controlled Handshake Line) | PB4 (20)# | Reserved for Future PWM | |
| 7 | nReset, active low | (12) | ||
| 8 | Network LED (PTI_EN) | PA4 (26)* | OUTPUT - Digital (Active High) | |
| 9 | Reserved (PTI_DATA) | PA5 (27)* | ||
| 10 | JTDO | PC2 (33) | ||
| 11 | JTCK | (32) | ||
| 12 | JTD | PC3 (34) | ||
| 13 | JTMS | PC4 (35) | ||
| 14 | JRST | PC0 (40) | ||
| 15 | RXD, SPI Slave In | PB2 (31) | UART Serial RX | |
| 16 | PWM Out | PA6 (29)# |
| |
| 17 | TXD, SPI Slave Out | PB1 (30) | UART Serial TX | |
| 18 | GND | |||
| 19 | Ultrasonic Digital In | PC1 (38)* |
| |
| 20 | Illuminance Analog In | PB7 (41)* | INPUT - Analog (0 - 1.2V) | |
| 21 | Network Button | PB6 (42)* |
|