A customer can register Command Passthrough to receive commands sent by a remote device(Dimmer Switch, Alarm Device) and pass commands through to Host Micro, RapidHA automatically processing the command payload.
This is typically done so that the command payload and corresponding action can be handled by the Host Micro-controller.
Step-by-step guide
Summary
- Setup Register Command Passthrough for desired cluster during startup config.
- Setup Network.
- Join Device.
- Bind Device to Coordinator.
- (If using RapidHA Desktop) Close/open com port
Register Command Passthrough
Command passthrough must be registered in the RapidConnect Firmware before the device is fully configured.
Please see the "Registering Command Passthrough" section of this guide for instructions on how this is done. If this step is not performed, any command received by the the RapidConnect Module will be discarded and no action taken.
Setup Network
This is done as normal
Join Device
This is done as normal.
ZLL Remotes usually require more steps to join to a ZBHA1.2 or ZB3.0 network. Please refer to Remote user manual for joining process.
Bind Device To Controller
Please follow Step 2 of this guide to bind the device cluster to the coordinator.