This page conveys release notes for firmware and software releases. 

RapidHA Lighting

RapidHA Lighting is a Daintree ControlScope-compliant ZigBee application specifically designed for integration into lighting products. It is based on the HA 1.2-compliant RapidHA application. 

Please note that devices running RapidHA firmware may be serially or OTA upgraded to RapidHA Lighting, but that upgrades from RapidHA Lighting to standard RapidHA should be avoided for the time being. 

RapidHA Lighting v1.0.13

The purpose of this release is to enable a limited subset of the /wiki/spaces/SPRHA15/pages/37093429 to RapidHA Lighting. In previous releases, RapidHA Lighting issued no outbound serial communications as it was not designed for operation against a Host processor. 

This release of RapidHA Lighting will still operate independently on the network as before and will also continue to operate the PWM GPIO in response to lighting events, but will now also inform a connected Host about incoming lighting events (On/Off, Move to Level and their combinations) via the serial interface. The serial protocol adheres to the RapidHA serial protocol with the incorporation of one new frame. 

New Features

This release will provide facilities for your Host processor to be notified of changes to the On/Off, Identify, and Level Control attributes/states so you can manipulate LED drivers accordingly. The serial frames issued by the application are described on the Serial Protocol page.