RapidHA Lighting Home

Summary

Many lighting vendors have recognized that wireless controls systems such as Daintree ControlScope and other ZigBee-based platforms can add significant value to their products. However, it can be difficult to get to market quickly with a robust and reliable solution that meets the requirements of these platforms. To that end, MMB has created the RapidHA Lighting firmware to run on our world-class RapidConnect hardware, providing out-of-the-box compatibility with Daintree ControlScope and other systems based on the ZigBee HA 1.2 specifications.

MMB is able to provide RapidConnect ZigBee modules that are loaded with firmware that will automatically join a Daintree ControlScope or ZigBee HA 1.2 network as a Dimmable Light device. The RapidConnect module can interface with an LED driver via UART or PWM to set the appropriate brightness level or on/off state in response to commands from the Daintree WAC or HA 1.2 coordinator. In other words, MMB’s RapidHA Lighting solution allows lighting OEMs to set up a functional wireless lighting demonstration as soon as they are able to wire up the module to their hardware!

The pages below provide more information about RapidHA Lighting hardware/firmware offering:

Cluster Support

Pinout

PA5 Protection Circuit:

Pin PA5 on the EM357 has a built-in function defined by Silicon Labs; if it is held low at startup, the EM357 will enter bootload mode.  MMB is in the process of updating the pinout to use a different pin that is available on our new Z357PA40 module. Until the new firmware implementing a different pinout is released, it is necessary to add the “protection circuit” shown below. R1 and R2 must have the same resistance.