Table of Contents

You may utilize the serial frames in the Manufacturing Library Header to run radio frequency tests

to validate your hardware during the development of your product
to pass FCC, ETSI certification
during production for end-of-line testing

Test Setup

The following serial sequence shows the template for all manufacturing library tests. Note it's possible to run different type of tests (Tone, Stream, Packets) within the same Manufacturing Library Start and Stop session.

The network state must be down to run the manufacturing library tests.

Transmit Tone

The following serial sequence shows how to send out an unmodulated tone.

Transmit Stream

The following serial sequence shows how to send out a stream of modulated symbols.

Transmit and Receive Packets

To test packet transmission, you want two modules – one as the transmitter, and the other as the receiver.

The following sequence shows how to set up the test on the transmitter side.

The following sequence shows how to setup the test on the receiver side.

Browser not supported